| Quote: |
|
Property Value ----------------------------------------------------------------------------------- General Overview Checksum of identification data supported; OK Device number 0 (ATA) Mapped volumes C,D Manufacturer Western Digital Capacity 160.04 GB Device buffer size 8.39 MB Device buffer type dual port, multisector, look-ahead Model number WDC WD1600JD-00HBB0 Firmware revision 08.02D08 Serial number WD-WMAL92552880 Master password revision unsupported Removable media device no Removable controller device no ATA/ATAPI version ATA/ATAPI-6 Device Geometry Logical cylinders 16383 Logical heads 16 Logical sectors/track 63 Current logical cylinders 16383 Current logical heads 16 Current logical sectors/track 63 Current logical sector capacity 16514064 Total user-addressable sectors 268435455 Max. user-LBA 48bit addr 312581808 S.M.A.R.T. Last S.M.A.R.T. status OK Attribute count 15 Attributes struct revision 16 Thresholds struct revision 16 Temperature report supported Temperature attribute 194 Current temperature 29°C Error logging supported Pre-power save supported Auto-save supported Simple self test time 2 min Extended self test time 62 min Conveyance self test time 5 min Last self test ok/never started Offline Data Collection Status enabled Last ODC ok ODC execution time 77 min 3 sec Off-line immediate supported Abort on new command unsupported Off-line read scan supported Self test supported Conveyance self test supported Selective self test supported DMA Modes UltraDMA modes supported up to 6 UltraDMA mode selected 5 Multiword DMA mode 0 supported Multiword DMA mode 1 supported Multiword DMA mode 2 supported Multiword DMA mode none Min MW-DMA transfer cycle time 120 ns Recom. MW-DMA transfer cycle time 120 ns PIO Modes PIO mode 3 supported PIO mode 4 supported Min PIO transfer cycle time (no flow control) 120 ns Min PIO transfer cycle time (flow control) 120 ns Serial ATA Capabilities Receipt host-initiated IPMR yes Native command queuing no Gen-1 signaling speed yes Gen-2 signaling speed no Serial ATA features Initiating interface power management unsupported DMA setup auto-activate optimization unsupported Non-zero buffer offsets in DMA setup FIS unsupported Capabilities LBA supported DMA supported S.M.A.R.T. error logging supported Standard timer valued supported IORDY supported Disable IORDY supported Write cache supported, enabled Look ahead supported, enabled Release interrupt unsupported World Wide Name (WWN) unsupported Media serial number unsupported Feature Sets S.M.A.R.T. supported, enabled Security mode supported, disabled Removable media unsupported Power management supported, enabled Advanced power management unsupported Host protected area supported, enabled CFA unsupported Power-up in standby supported, disabled Auto acoustic management supported, disabled 48bit address supported Device config overlay supported Media card pass through unsupported Streaming unsupported General purpose logging unsupported URG bit for READ STREAM DMA/PIO unsupported URG bit for WRITE STREAM DMA/PIO unsupported Time-limited Read/Write unsupported Time-limited Read/Write continuos unsupported Command Sets DEVICE RESET unsupported WRITE BUFFER supported, enabled READ BUFFER supported, enabled NOP unsupported DOWNLOAD MICROCODE supported READ/WRITE DMA QUEUED unsupported PACKET unsupported SERVICE interrupt unsupported SET MAX security extension supported, disabled SET FEATURES required yes FLUSH CACHE supported FLUSH CACHE EXT supported WRITE DMA/MULTIPLE FUA EXT unsupported WRITE DMA QUEUED FUA EXT unsupported IDLE IMMEDIATE with UNLOAD FEATURE unsupported Acoustic Management Current automatic value FEh (max performace) Recommended value 80h (min audibleness) Recom.test inter-seek delay invalid Security Security supported, disabled Locked no Frozen no Count expired no Enhanced security erase unsupported Driver Supports ATA commands yes Supports ATAPI commands yes Supports S.M.A.R.T. commands yes |