Ori Klein
Novice
Gender:
Joined: Sep 20 2005
Posts: 81
Location: CyberSpace
Offline
|
 Posted: Thu Nov 17, 2005 3:35 pm Post maybe stupid Post subject: Harddrive spin-up time? |
 |
 |
|
|
According to smart drive, the disk's threshhold is 21, max is 166...it's currently running on 167 (146% over!).
Is this going to be a problem?
I failed finding any hardware tech data confirming or denying.
smartdrive's Device info:
| Quote: |
Property Value
-----------------------------------------------------------------------------------
General Overview
Checksum of identification data supported; OK
Device number 0 (ATA)
Mapped volumes C,D
Manufacturer Western Digital
Capacity 160.04 GB
Device buffer size 8.39 MB
Device buffer type dual port, multisector, look-ahead
Model number WDC WD1600JD-00HBB0
Firmware revision 08.02D08
Serial number WD-WMAL92552880
Master password revision unsupported
Removable media device no
Removable controller device no
ATA/ATAPI version ATA/ATAPI-6
Device Geometry
Logical cylinders 16383
Logical heads 16
Logical sectors/track 63
Current logical cylinders 16383
Current logical heads 16
Current logical sectors/track 63
Current logical sector capacity 16514064
Total user-addressable sectors 268435455
Max. user-LBA 48bit addr 312581808
S.M.A.R.T.
Last S.M.A.R.T. status OK
Attribute count 15
Attributes struct revision 16
Thresholds struct revision 16
Temperature report supported
Temperature attribute 194
Current temperature 29°C
Error logging supported
Pre-power save supported
Auto-save supported
Simple self test time 2 min
Extended self test time 62 min
Conveyance self test time 5 min
Last self test ok/never started
Offline Data Collection
Status enabled
Last ODC ok
ODC execution time 77 min 3 sec
Off-line immediate supported
Abort on new command unsupported
Off-line read scan supported
Self test supported
Conveyance self test supported
Selective self test supported
DMA Modes
UltraDMA modes supported up to 6
UltraDMA mode selected 5
Multiword DMA mode 0 supported
Multiword DMA mode 1 supported
Multiword DMA mode 2 supported
Multiword DMA mode none
Min MW-DMA transfer cycle time 120 ns
Recom. MW-DMA transfer cycle time 120 ns
PIO Modes
PIO mode 3 supported
PIO mode 4 supported
Min PIO transfer cycle time (no flow control) 120 ns
Min PIO transfer cycle time (flow control) 120 ns
Serial ATA Capabilities
Receipt host-initiated IPMR yes
Native command queuing no
Gen-1 signaling speed yes
Gen-2 signaling speed no
Serial ATA features
Initiating interface power management unsupported
DMA setup auto-activate optimization unsupported
Non-zero buffer offsets in DMA setup FIS unsupported
Capabilities
LBA supported
DMA supported
S.M.A.R.T. error logging supported
Standard timer valued supported
IORDY supported
Disable IORDY supported
Write cache supported, enabled
Look ahead supported, enabled
Release interrupt unsupported
World Wide Name (WWN) unsupported
Media serial number unsupported
Feature Sets
S.M.A.R.T. supported, enabled
Security mode supported, disabled
Removable media unsupported
Power management supported, enabled
Advanced power management unsupported
Host protected area supported, enabled
CFA unsupported
Power-up in standby supported, disabled
Auto acoustic management supported, disabled
48bit address supported
Device config overlay supported
Media card pass through unsupported
Streaming unsupported
General purpose logging unsupported
URG bit for READ STREAM DMA/PIO unsupported
URG bit for WRITE STREAM DMA/PIO unsupported
Time-limited Read/Write unsupported
Time-limited Read/Write continuos unsupported
Command Sets
DEVICE RESET unsupported
WRITE BUFFER supported, enabled
READ BUFFER supported, enabled
NOP unsupported
DOWNLOAD MICROCODE supported
READ/WRITE DMA QUEUED unsupported
PACKET unsupported
SERVICE interrupt unsupported
SET MAX security extension supported, disabled
SET FEATURES required yes
FLUSH CACHE supported
FLUSH CACHE EXT supported
WRITE DMA/MULTIPLE FUA EXT unsupported
WRITE DMA QUEUED FUA EXT unsupported
IDLE IMMEDIATE with UNLOAD FEATURE unsupported
Acoustic Management
Current automatic value FEh (max performace)
Recommended value 80h (min audibleness)
Recom.test inter-seek delay invalid
Security
Security supported, disabled
Locked no
Frozen no
Count expired no
Enhanced security erase unsupported
Driver
Supports ATA commands yes
Supports ATAPI commands yes
Supports S.M.A.R.T. commands yes |
_________________
It matters if you just keep trying. |
|
FAQ
Search
Memberlist
Usergroups
Statistics
Register
Profile
Login to check your private messages
Login
I Have Had It!.!.!.!.... 
